Difference between revisions of "Hardware Log Book"

Revision as of 16:31, 17 June 2020

This is a list of changes made to Floodzilla Gage Network hardware. Be as specific as possible.

Date	Who	Change Made
4/22/2020		Unplugged Sno Falls Golf Course receiver; Fish Hatchery Rd sensor now using Tall Chief receiver
03/23/2020	Andy Obst	Replaced 14' Goose & Gander sensor/transmitter with 30' sensor (30' sensor mounted in bracket is 3.3" lower than the 14' sensor - made changes in Admin page)
05/20/20	Andy Obst	G&G, Sno Falls GC, Wild Canary, and 124th at Local Roots marked as "Offline" due to bad readings from vegetation interference.
05/20/20	Andy Obst	Keller Dairy Gage taken down for troubleshooting - had been offline for weeks. Offline because transmitter was found to be wet inside. Let transmitter dry out before redeploying.
06/01/20	Andy Obst	The "T" marked as "Offline" due to bad readings.
06/17/20	Andy Obst	Correcting measurement information from 03/23/20 for G&G sensor/transmitter. The 30' sensor is 1" lower than the 14' sensor that was originally there. Changed the "sensor height" in Floodzilla from 108.34' to 107.34' to account for the 1" difference between the two sensors. Check to be sure this was changed from the original measurement. I'm pretty sure on 03/23 I changed the sensor height back to the original when I realized the 3.3" measurement was incorrect.

@@ Line 27: / Line 27: @@
 |Andy Obst
 |The "T"  marked as "Offline" due to bad readings.
-|}
+|-
+|06/17/20
+|Andy Obst
+|Correcting measurement information from 03/23/20 for G&G sensor/transmitter. The 30' sensor is 1" lower than the 14' sensor that was originally there. Changed the "sensor height" in Floodzilla from 108.34' to 107.34' to account for the 1" difference between the two sensors. Check to be sure this was changed from the original measurement. I'm pretty sure on 03/23 I changed the sensor height back to the original when I realized the 3.3" measurement was incorrect.
+|}<br />