Difference between revisions of "SVPA-15"
Jump to navigation
Jump to search
GearyEppley (talk | contribs) |
GearyEppley (talk | contribs) |
||
| Line 8: | Line 8: | ||
|- | |- | ||
! scope="row"| Downstream | ! scope="row"| Downstream | ||
| − | | [[SVPA- | + | | [[SVPA-15B|SVPA-15B 124th W]] |
|} | |} | ||
=== Attributes === | === Attributes === | ||
Revision as of 18:12, 24 May 2020
Contents
SVPA-15: 124th St East at Local Roots Farm
| Status | ACTIVE |
|---|---|
| Upstream | SVPA-17 Goose & Gander |
| Downstream | SVPA-15B 124th W |
Attributes
- Road - 124th St (East - falling side of a flood)
- Slough
- Senses concrete pad when water is low
- Mounted on 4x4 post with cement pad
Installation Notes
Problems and Considerations (May 2020)
- Sensor Height – mount at same height or greater (15.04’).
- Cantilever arm must be level and static.
- Mount out over center of ditch if possible.
- RSSI issues – must be kept at same height for best RSSI.
- Access issues – field adjacent to ditch is often saturated, access to site by foot.
- Cannot reach transmitter to change batteries without taking the post down, shouldn't have to take post down to access transmitter.
- Position of post adjacent to the ditch is awkward and unsafe when using a ladder to try and access sensor.
- Could move the location closer to 124th St for better vehicle access.
- Sensing Cone Issues – the cone of detection is very wide at the ground level.
- Be sure sensor mounted out from the post by at least 24” (radius of cone at ground level).
- Problems with flood debris getting caught on post and being detected within the cone even after flood waters recede.
